Reason and treatment measures for the oil leakage machine

The blasting machine will inevitably cause oil leakage during work. For example: a series of oil leakage such as the engine of the shot engine, the shot engine switch oil leakage oil. So in the face of these sudden oil leaks, what should we do? Let's first understand the common oil leakage problems and processing methods of the shot engine.
1. The shot engine turning the axis leakage. 
Reasons and measures: If the axis and holes are worn with each other, the motorized transmission rod shaft and clutch handle shaft can be cut on the lathe to the lathe, and the corresponding sealing rubber ring is installed. If the aging of the decompression shaft is invalid, the new rubber ring should be replaced.
2. The engine shot engine screw oil is blocked, including cone blocking, flat blocking, and process blocking.
Causes and measures: If the screw is damaged or unqualified due to oil blocked screws, new pieces should be replaced; if the screw screw is damaged, the size of the thread can be increased and the new oil is equipped. If the tapered is blocked, you can use the tap attack to the flat block, and then add the pad.
3. The shot shot engine switch leaks oil, and the switch includes water valves, fuel tank switches and gasoline switches.
Reasons and measures: If the ball valve is worn or rusted, the rust between the ball valve should be removed and the appropriate steel ball should be selected for replacement. If the blasting machine is damaged by the tight filler and the fastening thread, the fastener should be repaired or replaced with the sealing filler. If the cone -colored side is not tightly connected, it can be grinded with fine door sand and oil.
4. The plane of the shot of the shot shot shot shot engine, the plane seams include two planes sealed with paper pads, asbestos and cork.
Reasons and measures: If there are ditch marks or burrs on the contact surface or the contact surface, the assorted, fine sandpaper or oil stones should be used according to the degree of contact surface, and large pieces can be used to milling. In addition, the assembled pads must be qualified, and at the same time clean and put down. If the bolts are loose, each fixed bolt should be tightened.
5. The pilling machine engine tube joint oil leakage, the pipe joint includes two categories: cone surface junction and hollow bolt pipe joint.
Reasons and measures: The cone -sided co -pipe joints include both ends of the pressure gauge, one end of the gasoline pipe, the ends of the high pressure oil pipe, and the tube joints from the fuel coarse filter to the end of the oil pump. You can see it and welded it on a good connector. If the low -pressure oil pipe connector is damaged, you can see the speaker mouth and re -make the speaker mouth. If the thread is damaged, it should be repaired or replaced. The hollow bolt joints include coarse fuel, fine filter, and low -voltage oil pipe joints of fuel injection pump. If the pad is damaged or the assembly is uneven, you can use plastic pads or repairs with the assorted. You can also use sandpaper to smooth it. If the tube is equipped with a pull marks on the plane, you can use fine sandpaper or an oil and stones to assemble the plane and pads; if there is impurities due to the coordination surface, you should pay attention to the cleaning of the body when assembling.