Steel wire shot stainless steel wire is specially made by metal drawing, cutting and other processing technology. The surface is bright and rust, no need for alkalization, the appearance is cylindrical, there is absolutely no air hole inside, good ductility, not crushed, the service life is 3-5 times of the alloy steel shot, economic development and environmental protection.
It is made of scrap steel wire rope and scrap automobile tire tire ring steel wire cutting. %, the most cost-effective. Scrap tire bead wire cut shot can replace 0.8mm, 1.0mm, 1.2mm, 1.4mm, 1.7mm cast steel shot or sand, can greatly increase the shot blasting coverage, reduce the cleaning time. In addition, because the general length size of steel wire shot is slightly larger than the diameter size, so in fact 1.0mm steel wire shot is the most widely used, can completely replace 1.2mm, 1.4mm, 1.7mm steel wire shot or cast steel shot or cast steel sand made of new steel wire, therefore, has been widely used.
High manganese steel wire was cut into steel wire pellets with equal length to diameter ratio and uniform hardness and density. It is an ideal shot blasting material for cleaning and strengthening metal projectiles. There are no pores, cracks, etc. Phenomenon, its high density, strong ejection force. Widely used in: aviation, automobile industry, casting industry, steel structure manufacturing, etc. The aim is to remove surface treatments such as oxide skin, sand and rust. It has the advantages of long service life, low consumption, high cleaning efficiency and strong toughness.
What are the advantages of wire shot cutting?
1, choose raw silk, high hardness, HRC48-52, high cleaning efficiency.
2, fine screen after uniform particle size, no long strip.
3. After the hinge, the surface is bright.